river table build part 1 using stone coat epoxy!
In this video I build my first river table out of some maple I had milled a few years ago. I used some boards that were splitting and used the split part for my river. I have to admit I was way too anxious to see the finished product that I didn't make sure or didn't take the time to make my pieces of wood flat and because of that I had to get my table milled down by the cnc machine which cost me a little extra. In the end it came out pretty good although it was quite a bit thinner then i wanted. on this project I used stone coat epoxy from Stone Coat in grants pass Oregon. They are a fantastic company with very knowledgeable staff and first rate customer service. I'm not being sponsored by them, i just want to stand behind an amazing product and good service. so if you need epoxy I highly recommend them.
I also used the professional services of Oregon Burls and figured hardwoods. They also have a fantastic staff of knowledgeable guys working for them. They took my project that needed much needed attention and turned it into something i could work with at a very reasonable price. They took my table to the cnc machine and routed down my high spots and gave me back something i could work with. If you are in the southern Oregon area I highly recommend them.